Club Car Gasoline Service Manual page 309

1. Remove the ball joint socket (2) from the forward and reverse shifter assembly ball stud (3).
2. Remove the ball joint socket (2) from the shifter arm ball stud (19) on the transmission (Figure 17-46)
(See Figure 17-5, Page 17-4).
3. Loosen the retaining nuts (22) on both ends of the cable (Figure 17-46).
4. Remove cable from car.
INSTALLATION OF THE FORWARD AND REVERSE SHIFTER CABLE
1. Position the cable so it goes over the battery and under intake expansion chamber. The cable contin-
ues on between the rear body and the back part of the expansion chamber to the transmission (Figure
17-45).
2. Install cable with retaining nut (22) and washer (23) on each side of the shifter cable support bracket at
the transaxle (Figure 17-5, Page 17-4, and Figure 17-46).
3. Install cable with retaining nut (22) and washer (23) on each side of the shifter cable support bracket at
the forward and reverse assembly (Figure 17-46).
4. Install the ball joint socket (2) on the shifter lever ball stud (19) on the transmission (Figure 17-46).
21
22
22
3
2
1
4
23
23
FIGURE 17-46
2
1
22
23
23
22
17
G
19 20
Page 17-23