Club Car Gasoline Service Manual page 304

Governor Assembly, Continued:
17
G
INTERNAL GOVERNOR
ALIGNMENT TOOL
4. Insert the governor arm shaft (18) down through governor shaft bore (Figure 17-35, Page 17-17).
5. Install the lower retaining ring (16) in the lower groove on the governor arm shaft. Check to be sure the
governor arm shaft rotates freely (Figure 17-36, Page 17-17).
6. To install the oil seal (24), a governor shaft cap jig (Club Car Part No. 1014105) is required. Place the
governor shaft cap jig on the governor arm shaft. Slide the new oil seal (24) over the tool until the oil
seal contacts the transmission housing. Remove governor shaft cap jig and use the oil seal press jig to
push the oil seal (24) into place (Figure 17-36, Page 17-17).
7. Install the top retaining ring (16) in the upper most groove on the governor arm shaft.
8. Apply a light film of new transmission lubricant to the outer race of the bearing. Then, using a press
sleeve that will apply pressure to only the outer race, press the ball bearing (1) into the bearing surface
for the governor shaft in the housing (34) (Figure 17-3, Page 17-3).
CAUTION
• DO NOT PRESS AGAINST INNER RACE OF BEARING.
9. Install the internal governor arm alignment tool (Club Car Part No. 1014107) into the inner race of ball
bearing (1) (Figure 17-37).
HOLD GOVERNOR GEAR (3) WITH
WEIGHTS HANGING DOWN, INSTALL
GOVERNOR SLEEVE (8) WHILE
INSERTING ALIGNMENT PIN INTO
SLEEVE NOTCH
Page 17-18
USE A DROP OF LOCKING
ADHESIVE ON THREADS
OF SCREWS (6)
1 6
7
FIGURE 17-37
3
8
WEIGHTS
NOTCH ON
SLEEVE (8)
FIGURE 17-39
RAM PRESS
DO NOT PRESS ON OUTER
RACE OF BEARING (1)
1
ALIGNMENT
PIN
TURN GOVERNOR ASSEMBLY
OVER, HOLDING IT TOGETHER BY
PRESSING ON THRUST WASHER (9).
THEN INSERT IT INTO BEARING (1).
4
5
3
2
FIGURE 17-38
9
GOVERNOR
1
FIGURE 17-40
1
2
4
ASSEMBLY