Controller - Club Car Gasoline Service Manual

3. Disconnect the gray wire (from the OBC) at the sense lead fuse, leaving the sense lead fuse connected
to the gray lead from the charger receptacle (Figure 21-1, Page 21-2).
4. Remove the 18 gauge red wire on the solenoid.
5. Disconnect the yellow wire and the green wire from the connectors three inches away from the Z plug
on the controller (Figure 21-1, Page 21-2).
6. Remove the 6 gauge and 10 gauge black wires from the B- of the controller (Figure 21-1, Page 21-2).
7. Remove the two 1/4 lock nuts holding the OBC.
8. Remove the OBC from the vehicle.
Installing the On-Board Computer
Install the OBC in reverse order of removal.

CONTROLLER

MOUNTING
8
TYPICAL
9
2 PLACES
10
CONTROLLER
Testing the Controller
See Test Procedures 4 (Page 21-27), 37 (Page 21-47), and 40 (Page 21-49).
3
2
4
7
5
6
FIGURE 21-84
TYPICAL
4 PLACES
TYPICAL
4 PLACES
1
TYPICAL
4 PLACES
TYPICAL
4 PLACES
21B
E
Page 21-57