Club Car Gasoline Service Manual page 198

CYLINDER SHROUD REMOVAL
13
WARNING
G
• WHEN MAKING TESTS OR REPAIRS, ALWAYS:
- WEAR SAFETY GLASSES OR APPROVED EYE PROTECTION.
- REMOVE KEY.
- DO NOT ATTEMPT TO SERVICE HOT ENGINE OR EXHAUST.
- DISCONNECT BATTERY AS SHOWN (FIGURE 12-1, PAGE 12-2).
- REMOVE SPARK PLUG WIRE.
• BEFORE REMOVAL AND DISASSEMBLY, CLEAN THE ENGINE.
• SEE SAFETY WARNINGS, PAGE 13-1.
1. Remove seat and access panel from rear body.
2. Remove spark plug wire from spark plug.
3. Loosen air intake hose clamp (7) from the intake manifold (5) and remove hose (6) (Figure 13-6).
4. Disconnect the fuel line (9) and vent tube (10) from the carburetor (4) (Figure 13-5).
WARNING
• PLUG FUEL LINE TO PREVENT GAS FROM DRAINING FROM LINE.
5. Remove governor guard (1) (Figure 13-6).
6. Remove clevis pin (2) from throttle lever (Figure 13-6).
7. Remove nuts at carburetor intake manifold (5) and remove manifold (Figure 13-6).
CAUTION
• DISCONNECT THE GOVERNOR LINKAGE FROM THE CARBURETOR BEFORE ATTEMPTING
TO REMOVE THE CARBURETOR. FAILURE TO DO SO COULD DAMAGE THE LINKAGE.
10
Page 13-8
9
FIGURE 13-5
4