Oil Pump - Club Car Gasoline Service Manual

4. Pull off the flywheel with a puller (CLUB CAR Part Number 1016627).
5. Take the flywheel key out of its groove.
Ignition Coil Inspection and Repair
See Testing the Engine Ignition Circuit - Section 12, Page 12-9.
Installation
1. Installation is the reverse of removal.
2. While tightening the two bolts (3), use a bronze feeler gauge to adjust the ignition coil air gap to 0.012
inch (0.304 millimeter) (Figure 13-60).
3. Torque the two ignition coil bolts to 30 in.lbs. (3.4 N-m).

OIL PUMP

Removal
WARNING
• WHEN MAKING TESTS OR REPAIRS, ALWAYS:
- WEAR SAFETY GLASSES OR APPROVED EYE PROTECTION.
- REMOVE KEY.
- DO NOT ATTEMPT TO SERVICE HOT ENGINE OR EXHAUST.
- DISCONNECT BATTERY AS SHOWN (FIGURE 12-1, PAGE 12-2).
- REMOVE SPARK PLUG WIRE.
• BEFORE REMOVAL AND DISASSEMBLY, CLEAN THE ENGINE.
• SEE SAFETY WARNINGS, PAGE 13-1.
1. Remove the six screws (1) and take off the oil pump cover (2) (Figure 13-61).
2. Peel off the oil pump cover gasket (3).
3. Take out the pump gear cover plate (4).
5
4
3
FIGURE 13-61
2
1
TYPICAL 6
PLACES
13
G
Page 13-31