Table of Contents
Advertisement
WHEEL REMOVAL
10
1. Slightly loosen the wheel rim mounting nuts on the wheel to be removed.
E
2. Raise the end of the vehicle from which the wheel is to be removed. Make sure that the wheels are off
of the ground. See WARNING below.
G
WARNING
• LIFT ONLY ONE END OF A VEHICLE AT A TIME. BEFORE LIFTING, LOCK THE BRAKES AND
CHOCK THE WHEELS THAT REMAIN ON THE FLOOR. USE A SUITABLE LIFTING DEVICE
(CHAIN HOIST OR HYDRAULIC FLOOR JACK) WITH 1000 LBS. (454 KG.) MINIMUM LIFTING
CAPACITY. DO NOT USE LIFTING DEVICE TO HOLD VEHICLE IN RAISED POSITION. ALWAYS
USE APPROVED JACKSTANDS OF PROPER WEIGHT CAPACITY TO SUPPORT THE VEHICLE.
3. Remove the wheel mounting nuts and remove the wheel.
WHEEL INSTALLATION
1. To install wheel(s), reverse the removal procedure.
2. Tighten the wheel rim mounting nuts to 50-60 ft.lbs. (68/81 N-m).
A
B
TIRE BEADS
POSITIONED
IN RIM WELL
VALVE STEM SIDE UP
C
Page 10-2
TIRE
WITH TIRE DEFLATED,
BEADS
LOOSEN TIRE BEADS
FROM RIM BY APPLYING
PRESSURE TO TIRE
SIDE WALLS
RIM
TIRE
FLANGE
BEADS
PRESSURE AGAINST
TIRE TOOL
USING TIRE TOOL,
CAREFULLY LIFT
TIRE BEAD OVER
RIM FLANGE
LIFT LOWER
TIRE BEAD
UP AND OVER
RIM FLANGE
FIGURE 10-1
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
