Club Car Gasoline Service Manual page 178

KILL LIMIT SWITCH
12
Removing the Kill Limit Switch (Figure 12-53)
G
WARNING
• WHEN MAKING ELECTRICAL TESTS OR REPAIRS, ALWAYS:
- WEAR SAFETY GLASSES OR APPROVED EYE PROTECTION.
- REMOVE THE KEY.
- PUT THE FORWARD AND REVERSE SWITCH IN NEUTRAL.
- DISCONNECT THE BATTERY AS SHOWN (FIGURE 12-1, PAGE 12-2).
• FOLLOW ALL PROCEDURES EXACTLY AS INSTRUCTED.
• SEE THE SAFETY WARNINGS ON PAGE 12-1.
1. Remove seat from body.
2. Disconnect battery wires as shown (Figure 12-1, Page 12-2).
3. Remove electrical component box cover (1).
4. Remove the two nuts (9) and washers (10) that secure the accelerator starter limit switch (11). Do not
disconnect the wires.
5. Disconnect the two white/black wires and the black wire from the kill limit switch (12).
6. Remove the kill limit switch (12).
Installing the Kill Limit Switch (Figure 12-53)
1. Install the kill limit switch (12) onto the two screws (16).
TYPICAL 2
PLACES
14
15
BLACK WIRE
ASSEMBLY
2. Connect the two white/black wires to the common (COM) terminal and the black wire to the normally
open (NO) terminal of the kill limit switch (12).
3. Install the accelerator starter limit switch (11) onto the two screws (16). Secure the switch in place
using the two washers (10) and the two nuts (9). Torque to 5 in.lbs. (0.6 N-m).
WARNING
• DO NOT OVER-TIGHTEN THE RETAINING NUTS. IF THE NUTS ARE OVER-TORQUED, LIMIT
SWITCHES COULD BE DAMAGED.
Page 12-42
1
9
11
10
12
8
TYPICAL 2
PLACES
13
16
TYPICAL 2
PLACES
21
FIGURE 12-53
20