Drive Clutch - Club Car Gasoline Service Manual

REMOVING THE DRIVE BELT
16
WARNING
G
• ONLY TRAINED TECHNICIANS SHOULD REPAIR OR SERVICE THIS VEHICLE. ANYONE DOING
EVEN SIMPLE REPAIRS OR SERVICE SHOULD HAVE KNOWLEDGE AND EXPERIENCE IN
GENERAL MECHANICAL REPAIR.
DRIVEN
CLUTCH

DRIVE CLUTCH

1. Grasp the belt midway between the drive and driven clutches. Lift upward on the belt to force the
sheaves of the DRIVEN clutch apart, then roll the belt off of the DRIVEN clutch (Figure 16-2). See
CAUTION below.
CAUTION
• MAKE SURE THAT FINGERS ARE NOT UNDERNEATH THE BELT WHEN ROLLING IT OFF OF
THE DRIVEN CLUTCH IN STEP 1.
2. Remove the belt from the drive clutch.
INSTALLING THE DRIVE BELT
1. Position the new belt on the DRIVE clutch, then start the belt over the driven clutch.
2. With the belt started onto the driven clutch, rotate both clutches and roll the belt over the driven clutch
sheaves and onto the clutch.
DRIVE CLUTCH
WARNING
• ONLY TRAINED TECHNICIANS SHOULD REPAIR OR SERVICE THIS VEHICLE. ANYONE DOING
EVEN SIMPLE REPAIRS OR SERVICE SHOULD HAVE KNOWLEDGE AND EXPERIENCE IN
GENERAL MECHANICAL REPAIR.
• ALWAYS WEAR SAFETY GLASSES OR APPROVED EYE PROTECTION WHILE SERVICING
VEHICLE. WEAR A FULL FACE SHIELD WHEN WORKING WITH THE BATTERY.
• TURN KEY SWITCH OFF, PLACE FORWARD AND REVERSE LEVER IN THE NEUTRAL POSI-
TION, AND REMOVE KEY PRIOR TO SERVICING.
• DO NOT WEAR LOOSE CLOTHING. REMOVE JEWELRY SUCH AS RINGS, WATCHES, CHAINS,
ETC. BEFORE SERVICING VEHICLE.
Page 16-4
GRASP BELT MIDWAY
BETWEEN DRIVE AND
DRIVEN CLUTCHES,
THEN ROLL BELT OFF
DRIVEN CLUTCH
FIGURE 16-2