Club Car Gasoline Service Manual page 48

Pedal Group Adjustment - Early 1995 Vehicles, Continued:
6
WARNING
E
• TO PROPERLY ADJUST BRAKE PEDAL AND CABLE ASSEMBLY, CHECK, AND ADJUST IF NEC-
ESSARY, THE FOLLOWING ITEMS IN THE ORDER LISTED:
G
- BRAKE PEDAL AND CABLE ADJUSTMENT. BEGINNING THIS PAGE.
- ACCELERATOR ROD ADJUSTMENT. SEE PAGE 6-3 THROUGH PAGE 6-6.
- ACCELERATOR PEDAL STOP ADJUSTMENT. SEE PAGE 6-6 THROUGH PAGE 6-8.
- PARK BRAKE ADJUSTMENT. SEE PAGE 6-8.
• IF ANY OF THE ITEMS ABOVE REQUIRE ADJUSTMENT, THE OTHER ITEMS MUST ALSO BE
CHECKED, AND ADJUSTED IF NECESSARY, IN THE ORDER LISTED ABOVE.
• FAILURE TO CHECK ALL ADJUSTMENTS IN THE ORDER LISTED COULD RESULT IN
IMPROPER VEHICLE OPERATION, PROPERTY DAMAGE, OR SEVERE PERSONAL INJURY.
1. ADJUST BRAKE PEDAL HEIGHT
yyyyy
1.1. To provide slack in the brake cables, loosen the hex nuts on the brake equalizer rod (Figure 6-1).
1.2. Loosen the jam nut (31) on the rubber pedal stop (22) (Figure 6-2) and rotate the stop until the
pedal is 6 inches (15.2 cm) from the floormat (Figure 6-3).
yyyyy
yyyyy
CORRECT PEDAL
POSITION IS 6
INCHES, (15.2 CM )
FROM FLOORMAT
TO BACK OF
BRAKE PEDAL
Page 6-2
FIGURE 6-1
yy
FIGURE 6-3
AFTER LOOSENING
JAM NUT (31) WITH A
7/16" SOCKET, ROTATE
PEDAL STOP (22) UPWARD
TO DECREASE DISTANCE
BETWEEN PEDAL AND
FLOORBOARD. ROTATE
IT DOWNWARD TO
INCREASE
FIGURE 6-2
TURN HEX NUTS UNTIL
THERE IS A 1/4" TO 1/2" (6.3 TO
12.7 MM) FREE PLAY OF
THE BRAKE PEDAL
FIGURE 6-4
22
31