Club Car Gasoline Service Manual page 482

Test Procedure 3, Continued:
23A
5. Check continuity of the AC circuit:
E
5.1. Carefully disconnect the two black wires attached to the contact terminals of the relay.
5.2. Connect a jumper wire between the two black wires.
5.3. With the relay bypassed, check the circuit across the AC cord plug blades (Figure 23-8).
5.4. If the reading is no continuity, check the wiring of the AC cord, the transformer primary coil leads,
and the jumper wire. If the charger is wired correctly, check individually the continuity of the AC
cord, the transformer primary coil, and the jumper wire.
TEST PROCEDURE 4 - DIODES
DANGER
• HIGH VOLTAGE! WITH THE CHARGER ON, THE VOLTAGE OF THE CAPACITOR INSIDE THE
CHARGER IS APPROXIMATELY 650 VOLTS. USE EXTREME CAUTION WHEN WORKING
NEAR CAPACITOR TERMINALS.
WARNING
• ONLY TRAINED TECHNICIANS SHOULD REPAIR OR SERVICE THIS CHARGER. ANYONE
DOING EVEN SIMPLE REPAIRS OR SERVICE SHOULD HAVE KNOWLEDGE AND EXPERIENCE
IN GENERAL ELECTRICAL REPAIR. FOLLOW ALL PROCEDURES EXACTLY AND HEED ALL
WARNINGS STATED IN THIS MANUAL.
• ALWAYS WEAR SAFETY GLASSES OR APPROVED EYE PROTECTION WHILE SERVICING
VEHICLE OR CHARGER. WEAR A FULL FACE SHIELD WHEN WORKING WITH BATTERIES.
• BEFORE ATTEMPTING ANY REPAIRS TO THE CHARGER, ALWAYS UNPLUG THE ELECTRI-
CAL CORDS, FIRST FROM THE AC OUTLET AND THEN FROM THE VEHICLE RECEPTACLE.
Use Test Procedure 4-A for single diode failures and testing of diodes. If both diodes have failed, use Test
Procedure 4-B.
Page 23-10
FIGURE 23-8