Reverse Warning Buzzer Installation; Reverse Warning Buzzer Limit Switch (If Equipped); Testing The Reverse Warning Buzzer Limit Switch; Reverse Warning Buzzer Limit Switch Removal - Club Car Carryall 295 Maintenance And Service Manual

ELECTRICAL COMPONENTS: GASOLINE
VEHICLES
2098
Figure 13-7 Reverse Warning Buzzer and Limit Switch

REVERSE WARNING BUZZER INSTALLATION

1. Install the reverse warning buzzer and secure it with two plastic rivets.
2. Connect the black wire from the wire harness to the negative (–) terminal on the buzzer.
3. Connect the red/white wire from the wire harness to the positive (+) terminal on the buzzer.
4. Lower and secure the hood.
5. Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline/Diesel Vehicles, Section
1, Page 1-4.

REVERSE WARNING BUZZER LIMIT SWITCH (IF EQUIPPED)

See General Warnings, Section 1, Page 1-2.

TESTING THE REVERSE WARNING BUZZER LIMIT SWITCH

See Test Procedure 25 – Reverse Warning Buzzer Limit Switch (If Equipped) on page 11-29.

REVERSE WARNING BUZZER LIMIT SWITCH REMOVAL

1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline/Diesel Vehicles on
page 1-3.
2. Raise the hood.
3. Disconnect the wires from the reverse warning buzzer limit switch (Figure 13-7, Page 13-13).
4. Remove the screws, nuts, washers, and lockwashers that secure the limit switch.
5. Remove the limit switch.
Reverse Warning Buzzer Limit Switch (If Equipped)
2008-2012 All-Wheel Drive Maintenance and Service Manual
13
Page 13-13