Reverse Buzzer Limit Switch - Club Car Carryall 300 2018 Maintenance And Service Manual

ELECTRICAL COMPONENTS: PEDAL-START
GAS VEHICLE

REVERSE BUZZER LIMIT SWITCH

See General Warnings on page 1-1.
TESTING THE REVERSE BUZZER LIMIT SWITCH
See Test Procedure 17 – Reverse Buzzer and Reverse Buzzer Limit Switch on page 18-35.
REVERSE BUZZER LIMIT SWITCH REMOVAL
1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery- Gasoline Vehicles on page 1-3.
2. Cut the wire tie that retains the limit switch leads to the instrument panel harness.
3. Disconnect the wire connector from the reverse buzzer limit switch (3) located on the back of the Forward/Reverse
shifter assembly (Figure 20-22, Page 20-26).
4. Remove the nuts (4) and washers (5) from the reverse buzzer switch (3) and slide the reverse buzzer switch off
of the screws (2).
REVERSE BUZZER LIMIT SWITCH INSTALLATION
1. Install the reverse buzzer switch (3) with two screws (2) (Figure 20-22, Page 20-26), that attach the buzzer to the
shifter assembly. Install washers (5) and tighten nuts (4) to 5 in·lb (0.6 N·m). See following CAUTION.
CAUTION
• Do not overtighten the retaining nuts. If the nuts are over tightened, limit switches could be damaged.
2. Place the Forward/Reverse handle in REVERSE and make sure that both switches actuate.
3. Connect the two wire connector to the reverse buzzer limit switch (3).
4. Connect battery and spark plug wire(s). See Connecting the Battery- Gasoline Vehicles on page 1-3.
5. Turn the key switch to the ON position. Shift the Forward/Reverse handle to the REVERSE position. The
buzzer should sound.
2018 Carryall 300 Maintenance and Service Manual
Reverse Buzzer Limit Switch
20
Page 20-25