Club Car Gasoline Service Manual page 154

Test Procedure 5, Continued:
12
G
DATA HOLD
AC/DC 500V MAX
250V MAX
AC V
DC V
OFF
Test Procedure 6 - Cam-Activated Neutral Lock-out Limit Switch:
This switch is located on the forward and reverse switch assembly. There are a black wire, a green wire, and
a white wire connected to this limit switch.
WARNING
• WHEN MAKING ELECTRICAL TESTS OR REPAIRS, ALWAYS:
- WEAR SAFETY GLASSES OR APPROVED EYE PROTECTION.
- REMOVE THE KEY.
- PUT THE FORWARD AND REVERSE SWITCH IN NEUTRAL.
- DISCONNECT THE BATTERY AS SHOWN (FIGURE 12-1, PAGE 12-2).
• FOLLOW ALL PROCEDURES EXACTLY AS INSTRUCTED.
• SEE THE SAFETY WARNINGS ON PAGE 12-1.
NEGATIVE
PROBE
1. Place the neutral lock-out cam in the SERVICE position, put the forward and reverse lever in the NEU-
TRAL position, and chock the wheels.
Page 12-18
SOLENOID
ELECTRICAL
COMPONENT BOX
FIGURE 12-23
LEVER UP
POSITIVE
NC
PROBE
NO COM
AC/DC 500V MAX
DC V
OFF
TESTER LIGHT
IS OUT. METER
READS 10.00
("1" FLASHES)
DATA HOLD
AC/DC 500V MAX
250V MAX
AC V
DC V
OFF
LEVER DEPRESSED
NEGATIVE
PROBE
NO COM
M
DATA HOLD
250V MAX
AC V
TESTER LIGHT IS
ON. METER READS
APPROXIMATELY
0 OHMS.
FIGURE 12-25
ELECTRICAL
COMPONENT
BOX
FRAME
FIGURE 12-24
POSITIVE
NC
PROBE
AC/DC 500V MAX
DC V
OFF
SOLENOID
DATA HOLD
250V MAX
AC V