Table of Contents
Advertisement
ELECTRICAL COMPONENTS – SUBARU EX40
REVERSE BUZZER LIMIT SWITCH
See General Warnings on page 1-2.
TESTING THE REVERSE BUZZER LIMIT SWITCH
See Test Procedure 16 – Reverse Buzzer and Reverse Buzzer Limit Switch on page 18-35.
REVERSE BUZZER LIMIT SWITCH REMOVAL
1.
Disconnect battery and spark plug wire(s). See Side-Post Battery: Disconnecting the Battery-Gasoline
Vehicles on page 1-3.
See Top-Post Battery: Disconnecting the Battery- Gasoline Vehicles on page 1-4.
2.
Disconnect the wires from the reverse buzzer limit switch (4) located on the back of the Forward/Reverse
assembly .
3.
Remove the nuts (2) and washers (6) from the neutral lockout limit switch (5) and slide the neutral lockout limit
switch off of the screws. Do not disconnect the wires.
4.
Remove the spacers (9) from the reverse buzzer limit switch (4) and slide the reverse buzzer limit switch off
the screws.
REVERSE BUZZER LIMIT SWITCH INSTALLATION
1.
Install the reverse buzzer limit switch (4), and then install two spacers (9) against the limit switch .
2.
Install the neutral lockout limit switch (5) with two washers (6) and two nuts (2). Tighten to 5 in·lb (0.6 N·m).
See following CAUTION.
CAUTION
• Do not overtighten the retaining nuts. If the nuts are over tightened, limit switches could be damaged.
3.
Place the Forward/Reverse handle in REVERSE and make sure that both switches actuate.
4.
Connect the orange wire to the common (COM) terminal and the red/white wire to the normally open (NO)
terminal of the reverse buzzer limit switch (4) .
5.
Connect battery and spark plug wire(s). See Side-Post Battery: Connecting the Battery-Gasoline Vehicles
on page 1-3.
See Top-Post Battery: Connecting the Battery- Gasoline Vehicles on page 1-4.
6.
Shift the Forward/Reverse handle to the REVERSE position. The buzzer should sound.
2016 Precedent Golf Car Maintenance and Service Manual
Reverse Buzzer Limit Switch
19
Page 19-27
Advertisement
Table of Contents
Troubleshooting
