Club Car Gasoline Service Manual page 523

4. Disconnect the AC cord white wire at the primary coil.
5. Disconnect the AC cord green wire at the charger base.
6. Use a pair of pliers to grip the strain relief bushing and remove it and the AC cord from the charger.
Installation of the AC Cord (Figure 23-36)
1. Insert the black, white, and green leads of the new AC cord into the charger through the hole in the
charger face.
2. Connect the black wire to the circuit breaker, the white wire to the primary coil, and the green wire to
the charger base.
NOTE
• MAKE SURE THAT THE GREEN (GROUND) WIRE IS TIGHTLY SECURED TO THE CHARGER
BASE.
3. Position the strain relief bushing on the AC cord.
4. Using pliers, install the strain relief bushing into the mounting hole in the charger face.
5. Install the charger cover.
23B
E
Page 23-51