Club Car Gasoline Service Manual page 503

WARNING
• IMPROPER CONNECTION OF THE EQUIPMENT-GROUNDING CONDUCTOR CAN RESULT IN
RISK OF AN ELECTRICAL SHOCK.
• DO NOT USE AN ADAPTER TO PLUG THIS CHARGER INTO A TWO-PRONG OUTLET OR
EXTENSION CORD. EXTENSION CORD OR OUTLET MUST ACCEPT GROUNDED THREE-
PRONG PLUG.
• THE USE OF AN IMPROPER EXTENSION CORD COULD RESULT IN RISK OF FIRE OR ELEC-
TRIC SHOCK.
• DO NOT OPERATE THIS CHARGER IF IT HAS RECEIVED A SHARP BLOW, WAS DROPPED, OR
WAS OTHERWISE DAMAGED. CHECK IT TO BE SURE THAT IT IS OPERATING PROPERLY
BEFORE PUTTING IT BACK IN USE.
Provide adequate ventilation for the charger. Keep all charger ventilation openings at least two inches away
from walls and other objects.
WARNING
• DO NOT ALLOW CLOTHING, BLANKETS, OR OTHER MATERIALS TO COVER THE CHARGER.
• CHARGERS CAN IGNITE FLAMMABLE MATERIALS AND VAPORS. DO NOT USE NEAR FUELS,
GRAIN DUST, SOLVENTS, THINNER, OR OTHER FLAMMABLES.
• KEEP CHARGER DRY - DO NOT EXPOSE TO RAIN. FOR STORAGE, KEEP THE CHARGER
INDOORS.
NORMAL CHARGER OPERATION
WARNING
• CONNECT CHARGER ONLY TO A PROPERLY GROUNDED SINGLE PHASE (3 WIRE) OUTLET.
• CHARGE BATTERIES ONLY IN A WELL VENTILATED AREA.
• TO CONNECT THE CHARGER PLUG TO THE VEHICLE RECEPTACLE, GRASP THE PLUG AND
PUSH IT STRAIGHT INTO THE RECEPTACLE. DO NOT ROCK OR BEND THE PLUG SIDEWAYS.
• TO DISCONNECT THE CHARGER PLUG FROM THE VEHICLE, GRASP THE PLUG AND PULL IT
STRAIGHT OUT OF THE RECEPTACLE. DO NOT PULL ON THE CORD. DO NOT TWIST, ROCK,
OR BEND THE PLUG SIDEWAYS.
• DO NOT USE THIS CHARGER IF:
- THE PLUG IS TOO LOOSE OR DOES NOT MAKE A GOOD CONNECTION.
- THE PLUG AND/OR RECEPTACLE FEEL HOTTER THAN NORMAL.
- THE PLUG PINS OR RECEPTACLE CONTACTS ARE BENT OR CORRODED.
- THE PLUG, RECEPTACLE, OR CORDS ARE CUT, WORN, OR HAVE ANY EXPOSED WIRES.
- THE PLUG, CORDS, CHARGER, OR RECEPTACLE ARE DAMAGED.
• USING THE CHARGER WITH ANY OF THE ABOVE CONDITIONS COULD RESULT IN A FIRE,
PROPERTY DAMAGE, OR PERSONAL INJURY. REPAIR OR REPLACE WORN OR DAMAGED
PARTS BEFORE USING THE CHARGER.
1. With the charger DC output cord disconnected from the batteries, connect the power supply cord to a
120 volt, 60 hertz outlet.
23B
E
Page 23-31