Club Car Gasoline Service Manual page 56

Installing the Brake Pedal Assembly - Early 1995 Vehicles, Continued:
6
E
G
2. Attach the equalizer rod (26) to the brake pedal weldment assembly (6) as shown (Figure 6-13).
3. Position and attach the brake pedal assembly and mounting blocks (23) to the vehicle frame as shown.
Tighten the bolts and nuts to 40-60 in.lbs. (4.5/7 N-m) (Figure 6-13). See NOTE below.
NOTE
• EACH HALF OF EACH MOUNTING BLOCK ASSEMBLY IS MARKED WITH AN A OR B. THE
HALVES MARKED A SHOULD BE ORIENTED TO THE TOP LEFT HAND AND BOTTOM RIGHT
HAND SIDES OF THE BRAKE PEDAL ASSEMBLY, AND THE HALVES MARKED B SHOULD BE
ORIENTED TO THE TOP RIGHT HAND SIDE AND BOTTOM LEFT HAND SIDE OF THE BRAKE
PEDAL ASSEMBLY (FIGURE 6-13).
4. Install the brake cables (14) on the equalizer rod using the clevis pins (17) and cotter pins (16) that
were removed when the brake pedal assembly was disassembled (Figure 6-13). Tighten the nut (24)
on the equalizer rod so that brake pedal free-play is 1/4 inch to 1/2 inch (6.35 mm to 12.7 mm) (Figure
6-4, Page 6-2). See NOTE at top of next page.
Page 6-10
FIGURE 6-13