Forward And Reverse Limit Switches - Club Car Gasoline Service Manual

FORWARD AND REVERSE (F&R) LIMIT SWITCHES
20B
The F&R anti-arcing limit switch, reverse buzzer limit switch, and reverse half-speed limit switch are located
on the F&R switch and are activated by a cam on the F&R switch rotor (Figure 20-14).
E
Testing the Limit Switches
1. F&R Anti-Arcing Limit Switch: See Test Procedure 3, Page 20-13.
2. Reverse Buzzer Limit Switch: See Testing The Reverse Buzzer Circuit, Page 20-30.
3. Half-Speed Reverse Limit Switch: See Test Procedure 12, Page 20-21.
Removing the Limit Switches
1. Remove all three limit switches from F&R switch by removing two screws (5), lock washers (4) and nuts
(3). Label each wire prior to disconnecting wire terminals from each switch.
7
8
SEAT SUPPORT
FRONT PANEL
Installing Limit Switches
Install in reverse order of disassembly. Insert labeled wires on the common (COM) terminal and labeled
wires on the normally open (NO) terminal of each switch. Torque screws to 5 in.lbs. (0.6 N-m). (If wires were
not labeled during removal, see Figure 20-2, Page 20-3, or Figure 20-3, Page 20-4 for proper wiring.)
After installation, be sure that when the rotor is turned, the lever arm of each switch is pressed and released
per chart at the top of page 20-29. If not correct, inspect the Forward and Reverse rotor and limit switches for
damage.
Page 20-28
3
6
F&R ANTI-ARCING LIMIT SWITCH
REVERSE BUZZER LIMIT SWITCH
HALF-SPEED REVERSE LIMIT SWITCH
4
1
9
FIGURE 20-14
5