Club Car Gasoline Service Manual page 385

D.C. CORDSET
9
SEAT SUPPORT
Removing the Receptacle
1. Remove the 10 gauge red wire (4) from the positive post of battery No. 1, and then pull the 10 gauge
red wire to the receptacle (2) (Figure 20-17).
2. Locate the 1/4" "quick disconnect" terminal on the 10 gauge grey wire from the charger receptacle. Dis-
connect the 10 gauge grey wire (3) at this terminal, leaving the sense lead fuse (1) attached to the grey
wire from the on-board computer (Figure 20-17).
3. Remove the 10 gauge black wire (5) from the charger receptacle using a ratchet and a 3/8" socket.
4. Use a phillips screwdriver to remove the four screws (9) from the bezel (7), and the three screws (12)
from receptacle (2).
Installing a New Receptacle (Figure 20-17)
1. Install the bezel (7) with four screws (9) through the bezel and body and into the receptacle backing
plate (8). Torque screws to 9-13 in.lbs. (1.0/1.5 N-m) (Figure 20-17).
2. Insert the fuse and receptacle assembly (2) through the receptacle backing plate and into the bezel as
shown, then install the three mounting screws (12).
3. Thread the 10 gauge red wire (4) through the tie wraps on the front body support and attach the con-
nector to the positive post of battery No. 1 (See Figure 23-20, Page 23-29).
7
FRONT PANEL
FIGURE 20-17
6
8
5
11
10
2
3
12
4
1
20A
E
Page 20-35