Club Car Gasoline Service Manual page 201

1
2
1
1
FIGURE 13-11
2. Remove head gasket (3). Note the position of the two dowels (4) as shown (Figure 13-12).
3. Compress the valve spring with the valve spring compressor (5) (CLUB CAR Part Number 1016411-
01) and remove the collet halves (6) (Figure 13-13).
4. Remove spring compressor, take out the upper retainer (7), the spring (8) and the spring seat (9) (Fig-
ure 13-13).
NOTE
• THE SPRINGS SEATS (9) CAN ONLY BE REMOVED WITH THE VALVE STEM SEALS (11)
REMOVED (FIGURE 13-14).
5. Remove valve (10) (Figure 13-13).
6. If necessary, remove valve stem seal with a screwdriver and replace seal.
CAUTION
• TO KEEP THE SCREWDRIVER FROM DAMAGING THE CYLINDER HEAD FLANGE SURFACE,
PUT A PIECE OF HEAVY CARDBOARD OR WOOD BETWEEN THEM (FIGURE 13-14).
• REMOVAL WILL DAMAGE THE STEM SEAL. IF STEM SEAL DOES NOT NEED REPLACEMENT,
DO NOT REMOVE IT.
5
6
10
FIGURE 13-13
1
1
1
6
11
7
8
9
FIGURE 13-12
yy
yy
FIGURE 13-14
Page 13-11
13
G
4
3
9