Charger Fuse Link Assembly - Club Car Gasoline Service Manual

Installing the Ammeter, Continued:
23A
E
5. Connect the bus bar from the fuse links to the right post of the ammeter. Make sure there is a washer
on each side of the bus bar.
6. Install the nuts on both posts of the ammeter and tighten slightly more than finger tight. Then while
holding the outside nut, turn the inside nut counterclockwise 1/4 of a turn.
7. Install the charger cover.
8. Plug the charger into a vehicle and make sure the ammeter is operating properly.

CHARGER FUSE LINK ASSEMBLY

Removing the Fuse Link Assembly
1. Remove the charger cover.
2. Remove both secondary transformer leads and the bus bar from the back of the fuse link assembly.
3. Remove the fuse link retaining screws from the face of the charger and remove the fuse link assembly.
Installing the Fuse Link Assembly
1. Place the plastic cover over the fuse assembly and position the assembly on the charger face, then
install the mounting screws from the front of the charger face.
2. Install the bus bar over the center branch of the fuse assembly and ammeter stud. Tighten to 24-30
in.lbs. (2.7/3.4 N-m).
3. Connect one of the secondary transformer leads (black) to one of the remaining terminals on the back
of the fuse assembly. Connect the remaining secondary transformer lead (black) to the remaining ter-
minal. Tighten to 24-30 in.lbs. (2.7/3.4 N-m).
4. Install the charger cover.
Page 23-26
4
6
5
FIGURE 23-18
2
1
3