Battery Warning Light - Club Car Gasoline Service Manual

5. Connect the 18 gauge green/white wire to F&R limit switch No. 1. Connect the 18 gauge black (2),
white (3), and blue (4) wires to the multi-step potentiometer. See Figure 20-2, Page 20-3 for proper wir-
ing connections.
6. Connect the accelerator rod (1) to the potentiometer.
7. Install and connect the No. 5 and No. 6 batteries.
POTENTIOMETER
1
9

BATTERY WARNING LIGHT

Removing the Battery Warning Light
1. Disconnect the battery wires as shown (Figure 20-1, Page 20-2).
2. Remove center dash.
2.1. Remove the plastic cap covering the screw on each side of the center dash.
2.2. Loosen (but do not remove) the screw on each side of the center dash panel.
2.3. Insert screwdriver at the top center of the dash between dash and cowl brace. Gently pry center
dash out slightly from under edge of cowl brace.
2.4. Pull center dash out approximately one inch from the frame and then bend the top right corner of
the center dash inward while pulling the top of the panel out and down. See Note at top of Page
20-42.
4
5
POTENTIOMETER
MOUNTING
FIGURE 20-20
3
2
10
8
6
7
TYPICAL
2 PLACES
Page 20-41
20A
E