Front End Wiring Harness; Front Park And Signal Lamps; Seal Beam; Typical 6-Cylinder Engine Harness Installation - Pontiac Grand Prix Service Manual

12-22 1969 PONTIAC SERVICE MANUAL
-VOLTAGE REG.
D U R I N G INSTALLATION
AS THIS M A Y D A M A G E CONTACTS.
INSTALL BY P U S H I N G STRAIGHT ON
A N D TIGHTENING SCREW I W T H
BULK HEAD C O N N E C T O R S MUST BE
TEMP. SWITCH
INSTALLED TOGETHER 1
VIEW C
IL PRESSURE SWITCH
Fig.
12-22
Typical 6-Cylinder Engine Harness Installation
FRONT END WIRING HARNESS
Front end wire harness routing and connection may be
determined from Fig.
12-24.
SEAL BEAM
ALL-REMOVE AND REPLACE (INCLUDES
ADJUSTMENT)
1.
Remove bezel.
2.
Remove seal beam rim retaining screws.
4.
To replace,.reverse removal procedure.
5.
Adjust headlights as shown in Fig.
12-25.
If
commercial aiming devices are used, follow manufac-
turer's instructions as well as local variations.
FRONT PARK AND SIGNAL LAMPS
PONTIAC AND TEMPEST
-
REMOVE AND REPLACE
1.
To remove bulb, remove lens.
2.
Remove retaining screws.
3. D i s c o ~ e c t electrical feed w i r e .
4.
Remove lamp.
3. Remove wire connector and remove seal beam.
5. To replace reverse removal procedure.