Removal Of Oil Pump; Removing Front Seal; Removing Pump Assembly; Removing Direct Clutch Assembly - Pontiac Grand Prix Service Manual

TURBO HYDRA-MATIC-M-40
7E-15
Fig. 7E-29 Removing Front Seal
REMOVAL OF OIL PUMP
1. If necessary to replace, pry front seal from pump
(Fig. 7E-29).
2. Remove pump attaching bolts.
3. Install 3/8"-16 threaded slide hammer Adapters J
6125-2 into bolt holes in pump body, attach Slide
Hammers J 6125-1 and remove pump assembly from
case (See Fig. 7E-30 for location of threaded holes).
4. Remove and discard pump to case seal ring and
gasket.
5. Remove forward clutch assembly and turbine shaft
from transmission (Fig. 7E-3 1).
6. Remove forward clutch hub to direct clutch housing
Fig. 7E-31 Removing Forward Clutch Assembly and
Turbine Shaft
thrust washer if it did not come out with foryard
clutch housing.
7. Remove direct clutch assembly (Fig..7E-32).
NOTE:
I f
necessary, remove manual linkage as follows:
a. Unthread jam nut hol&ng detent lever to manual
shaft.
b. Remove manual shaft retaining pin from case (Fig.
7E-33).
CA UTZON: Do not lose jam nut as
it
becomes pee from
manual shafi.
c. Remove manual shaft,and jam nut from case (Fig.
7E-34).
d. Remove parking actuator rod and detent lever
assembly.
e. Remove attaching screws and parking bracket (Fig.
Fig. 7E-30 Removing Pump Assembly
Fig. 7E-32 Removing Direct Clutch Assembly