Removing Eccentric And Distributor Drive Gear Pin; Installing Bearing; Removing Bearing And Seal; Installing Seal - Pontiac Grand Prix Service Manual

SIX CYLINDER ENGINE 6-23
Fig. 6-40 Removing Eccentric and Distributor Drive
Gear Pin
13. Remove oil pan bolts.
14. On Tempest raise engine approximately 4 1/2".
Apply a rearward force on the engine-transmission
assembly until oil pan clears the flywheel housing and
remove oil pan.
On Firebird raise engine approximately 2" or until oil
pan clears the flywheel housing and remove oil pan.
REPLACE
1. Install new gasket on oil pan.
2. Apply rearward force to engine-transmission assem-
bly sufficient to allow oil pan to clear flywheel housing
(Tempest).
Fig. 6-42 Installing Bearing
3. Install oil pan and tighten retaining bolts to 12 Ib. ft.
4. Lower engine, remove engine support bracket and
install engine insulator bracket to frame thru bolts.
5. Tighten transmission insulator to crossmember bolts
to 30 Ib. ft.
6. Replace flywheel cover and starter assembly.
7. Lower vehicle.
8. On air-conditioned vehicles, replace compressor and
adjust belt tension.
9. Replace air cleaner assembly.
10. Refill crankcase.
1 1. Connect battery cable.
Fig. 6-41 Removing Bearing and Seal Fig. 6-43 Installing Seal