Installation Of Governor, Speed0 Drive Gear And Extension Housing; Installing Valve Body Assembly - Pontiac Grand Prix Service Manual

TURBO HYDRA-MATIC TRANSMISSION M-38 76-47
Fig. 7G-122 Installing Valve Body-to-Spacer Plate
Gasket
CA
UTION: If number one ( # I ) .
check ball is omitted or
incorrectly placed, transmission failure will result due to
minimum line pressure.
12. Install valve body spacer plzte-to-case gasket and
valve body spacer plate.
13. Install spacer support plate and its seven (7) bolts
loosely (Fig. 7G- 15).
14. Install valve body-to-spacer plate gasket (Fig. 7G
122).
15. While connecting manual control valve link-to-r-
ange selector inner lever, install valve body assembly
Fig. 7G-123 lnstalling Valve Body Assembly
Fig. 7G-124 Installing Detent Spring and Roller to
Valve Body
to its spacer plate gasket, install seventeen (17) valve
body-to-case attaching bolts and torque these bolts
and seven (7) spacer support plate bolts to 13 lb. ft.
(Fig. 76-123).
4
CA UTION: When handling valve body assembly, do not
touch sleeves as retainer pins will fall into transmission.
16. Connect detent control valve link to detent valve
actuating lever, insert free end of link into its case
opening,' connect actuating lever assembly to valve
body actuating lever bracket and retain the lever
assembly to the lever bracket with its retaining pin.
17. Install detent roller and spring assembly to valve
body with the remaining valve body-to-case attaching
bolt, torquing to 13 lb. ft. (Fig. 7G-124).
18. Install strainer assembly and new gasket, retaining
it with two (2) screws.
NOTE: Flush out strainer and check for foreign
material.
19. Install new oil pan gasket and oil pan. Install and
torque its thirteen (13) bolt and washer assemblies to
12 lb. ft.
INSTALLATION OF GOVERNOR, SPEED0 DRIVE
GEAR AND EXTENSION HOUSING
1. Install governor assembly, new O-ring seal, cover
and retainer wire.
2. Place speedometer drive gear retaining clip into hole
in output shaft, align slot in speedometer drive gear