Installation Of Governor; Installation Of Speedometer Driven Gear; Installation Of Converter Assembly - Pontiac Grand Prix Service Manual

13-58 1969
PONTIAC SERVICE MANUAL
Fig. 7E-177 lnstalling Control Valve Assembly and
Governor Pipes
2. Install O-ring seal on vacuum modulator.
3. Install vacuum modulator into case (Fig. 7E-179).
4. Install modulator retainer and attaching bolt.
Torque bolt to 18 lb. ft.
INSTALLATION OF GOVERNOR
1. Install governor into case (Fig. 7E-180).
2. Attach governor cover and new gasket with four (4)
attaching bolts. Torque bolts to 18 lb. ft.
INSTALLATION OF SPEEDOMETER DRIVEN GEAR
1. Install speedometer driven gear (Fig. 7E-181). 2.
1
DETENT ROLLER A N D
I
VACUUM MODULATOR
Fig. 7E-179 lnstalling Vacuum Modulator and Valve
Install speedometer driven gear retainer and attaching
bolt.
INSTALLATION OF CONVERTER ASSEMBLY
With the transmission in cradle or portable jack, install
the converter assembly into the pump assembly,
making certain that the converter hub drive slots are
fully engaged with the pump drive gear tangs and the
converter installed fully towards the rear of the
transmission.
Fig. 7E-178 lnstalling Detent Roller and Spring
Assembly Fig. 7E-180 lnstalling Governor