Pontiac Grand Prix Service Manual page 121

4-6 1 ~ 6 9 PONTIAC SERVICE MANUAL
Fig. 4-4 Main Leaf of Leaf Spring
-
Firebird
NOTE: Use care to keep bushing proper& aligned. 4. Position control arm in place and install pivot bolts.
While holding nut, tighten pivot bolt to 110 lb. ft.
2. Position control arm in place and install pivot bolt.
torque or while holding pivot bolt, tighten nut to 80 lb.
-
-
ft. torque.
3. While holding nut, tighten pivot bolt to 110 lb. ft.
torque or while holding pivot bolt, tighten nut to 80 lb.
NOTE: Car must be at curb height when tightening
ft. torque.
pivot bolts.
NOTE: Car must be at curb height when tightening
pivot bolts.
4. Remove jack stand and lower car.
REMOVE (IN CONTROL ARM)
1. Remove upper control arm
(see
UPPER CONTROL
ARM -EXCEPT FIREBIRD
-
REMOVE).
2. Arrange tools as shown in Fig. 4-7 and press
bushing from control arm.
INSTALL
1. Install bushing in control arm by arranging tools as
shown in Fig. 4-8 and press into place.
Fig. 4-6 Installing Upper Control Arm Rear Bushing
-
Except Firebird
2. Install upper control arm (see UPPER CONTROL
ARM -EXCEPT FIREBIRD
-
INSTALL).
3. Install bushing in control arm by arranging tools as
shown in Fig. 4-8 and press into place.
NOTE: Use care to keep bushing properly aligned.
Fig. 4-5 Removing Upper Control Arm Rear Bushing
Fig. 4-7 Removing Upper or Lower Control Arm
Except Firebird Bushing-Except Firebird