Oil Pan; Housing Mounting Bolts; Oil Filter Bypass Valve - Pontiac Grand Prix Service Manual

6-22 1969
PONTIAC SERVICE MANUAL
Fig. 6-38 Housing Mounting Bolts
SHAFT AND SPROCKET ASSEMBLY
-
SHAFT SEAL
AND/OR BEARING
-
FUEL PUMP
-
ECCENTRIC
AND DISTRIBUTOR DRIVE GEAR
1. Remove housing assembly.
2. Observing and recording location of sprocket timing
mark and direction of distributor rotor, remove
distributor.
3. Remove fuel pump eccentric and distributor drive
gear retaining pin (Fig. 6-40).
NOTE: Position shaft assembly so as to allow adequate
clearance in housing body for pin removal.
4. Remove shaft and sprocket assembly from housing.
5. Inspect shaft assembly seal and bearing.
6. If necessary to replace bearing or seal, use J 22264
and slide hammer to remove seal or bearing and seal
together (Fig. 6-4 1).
7. Use tool J 22267-1 and install bearing (Fig. 6-42).
8. Use tool J 22267-1 and -2 and install seal (Fig.
6-43).
9. Reassemble by reversing steps 1 thru 4.
OIL PAN
REMOVE
2. Remove air cleaner assembly.
3. On air-conditioned cars, remove compressor from
mounting brackets and position to one side.
4. Inspect all water hoses and wiring harness for
proper .routing to prevent excessive binding when
engine is raised.
NOTE: Before raising vehicle prop hood open at least 6"
to insure adequate clearance between timing belt cover
and inner hoodpanel.
5. Raise vehicle and drain crankcase.
6. Remove starter assembly and flywheel cover.
7. Reroute or disconnect any wiring between bellhous-
ing and floor pan to insure against damage when
bellhousing contacts floor pan.
8. Loosen transmission insulator to crossmember
retaining bolts.
9. Remove right and left engine insulator to frame
bracket thru-bolts.
10. Rotate harmonic balancer until timing mark is at
bottom. (This puts the crankshaft counterweights in
the proper position.)
11. Bolt J 22345 (Tempest) or J 22773 (Firebird)
engine support bracket to front of harmonic balancer.
NOTE: Safety bracket on Firebird tool must engage in
crossmember rein forcement bar (Fig.
6-1 0).
12. With suitable equipment, raise engine at J 22345 or
J 22773 until insulators clear frame brackets.
1. Disconnect battery cable. Fig. 6-39 Oil Filter Bypass Valve