Installing Front Bearing Retainer Oil Seal - Pontiac Grand Prix Service Manual

Fig. 78-22 lnstalling Front Bearing Retainer Oil Seal
1
BLOCKING RING ALIGN WITH
Fig. 78-23 lnstalling Second
-
Third Speed
Synchronizer and Gear
12. Install extension housing. Spread snap ring in
housing to allow snap ring
to
drop around rear bearing
(Fig. 7B-13). Ress on end of mainshaft until snap ring
engages groove in rear bearing.
Fig. 78-24 lnstalling First Speed Gear and
Synchronizer
Fig. 78-25 lnstalling Rear Bearing
13. Install fourteen (14) bearing rollers in the main
drive
gear,
heavy grease to hold bearings in
into case. Install extension housing to case bolts.
plaa (Fig. 7B-26).
Torque to 45 Ib. ft.
14. Assemble third speed blocking ring on main drive CAUTION:
Make certain that notches in blocking ring
gear. align with keys in second-third synchronizer.
15. Pilot main drive gear and third speed blocking ring
18. Install front bearing onto main drive gear. Outer
over front of mainshaft.
snap ring groove must be toward front of gear.
16. Using heavy grease, install extension housing to
19. Install retaining snap ring.
case
gasket.
20. Install front bearing retainer, gasket and four
17. Install extension housing and mainshaft assembly
attaching bolts, torquing bolts to 10 lb. h.