Flywheel Or Clutch Pilot Bearing; Exploded View Of Clutch And Flywheel - Pontiac Grand Prix Service Manual

CLUTCH,
MANUAL TRANSMISSIONS 7-5
tighten to 25 Ib. ft. torque. Remove spare main drive
8. Install transmission. See TRANSMISSION SEG
gear used to align clutch disc.
TION.
3. Lubricate surface of release fork fmgers which
contact release bearing, sides of pressure plate lugs
protruding through cover plate stamping and release
fork ball fulcrum with high melting point wheel
bearing lubricant and install release fork.
4. Apply a light coat of grease to inner diameter of
clutch release bearing and fill recess in inner diameter
of bearing.
5. Install clutch- release bearing to fork in flywheel
housing.
NOTE: When installing a new bearing be sure the same
length bearing is installed as was removed.
CAUTION: Use two transmission guide pins in upper
holes in clutch housing.
9. C o ~ e c t clutch linkage to release fork.
10. Adjust pedal lash. See lash adjustment under
Periodic Senice.
NOTE: If interference is encountered with the clutch
fitlly engaging the transmission shifr linkage should be
adjusted as outlined in sections 7A thru 70, because the
shij linkage interlock mechanism is controlled by clutch
action.
FLYWHEEL OR CLUTCH PILOT BEARING
6. Apply a light coat of high melting point wheel
bearing lubricant to full length of outer diameter of
REMOVE AND REPLACE
transmission release bearing support (retainer).
1. Remove transmission.
CA UTZON: Do not over lubricate.
2. Remove clutch assembly.
7. Install flywheel housing and tighten bolts to 40 lb.
ft. torque.
3. If clutch pilot bearing is to be replaced, use cold
4
Clutch Cover
to
F l y w h ~ l
Clutch Cover and
Prouure Ploh
Aambly Clukh Releom
Clukh Releose Boll
-
Fig. 7-5
Exploded View
of
Clutch
and Flywheel
Assembly