Side Cover Assembly - Pontiac Grand Prix Service Manual

FOUR-SPEED SAGINAW MANUAL TRANSMISSION
7C -3
GEARSHIFT
CONTROL ROD
-STEERING
COLUMN
SHIFTER LEVER
6
LUBRICATE WITH
CHASSIS LUBRICANT
16 LB. FT.
BRAKE PIPE
A
20 LB. FT.
A
84 LB. IN.
TORQUE SYMBOL IS ADJACENT TO- FRAME
4
CALLOUT FOR MEMBER TO BE TORQUED
Fig. 7C-2 Firebird Back Drive Linkage
PIVOT PIN
SHIFTER SHAFT
2. Install the 1st and 2nd detent cam onto the detent
NOTE: Detent cams are not interchangeable.
cam pivot pin, with the detent cam spring tang
projecting up over the 3rd and 4th shifter shaft
3. Install pivot retainer C-ring to pivot shaft and hook
opening. Install the 3rd and 4th detent cam onto the
spring into notches in detent cam spring tangs.
detent cam pivot pin, with the detent cam spring tang
up over the kt and 2nd shifter shaft opening.
4. Install kt-2nd and 3rd-4th shifter shaft assemblies in
cover, being careful not to damage seals. Install shift
forks to shifter shafts, lifting up on detent cams to
allow forks to seat fully.
NOTE: Shifrlorks are not interchangeable.
5. Install reverse detent ball and spring to cover, then
install reverse shifter shaft to cover.
6. Install outer shifter levers, flat washer, lock washers
and bolts.
7. Position shift forks
in
neutral position.
8. Position cover gasket on case and carefullv vosition
side cover into pl&x, making sure the shift &ks align
with their respective sliding sleeves.
9. Install cover attaching bolts and torque evenly to 20
Ib. ft.
Fig. 7C-3 Side Cover Assembly
10. Remove filler plug and add 3 1/2 pints of
SAE 80
or 90 multi-purpose gear lubricant.