Dimmer Switch; Back Up Lamp & Neutralizer Switch - Pontiac Grand Prix Service Manual

12-32
1969 PONTI AC SERVICE MANUAL
4. To replace, reverse removal procedure.
IGNITION SWITCH
The ignition switch is mounted on the lower
steering column and is actuated by a rod from
the ignition lock cylinder.
ALL
-
REMOVE AND REPLACE
1. Disconnect battery.
2. Loosen toe pan screws.
3. Remove column to instrument panel attaching
nuts.
4. Lower column and disconnect switch wire
connectors.
5. Remove switch attaching screws and remove
switch.
6. To replace move key lock to OFF-LOCK
position.
7. Move actuator rod hole in switch to
OFF-LOCK position Fig. 12-33.
8. Install switch with rod in hole.
9. Reverse remaining procedure referring to
section 9 for column alignment instructions.
DIMMER SWITCH
ADJUST MANUAL TRANSMISSION
1. Loosen switch retaining screws and move lever to
reverse position.
2. Align hole in drive tang with slot in switch and
insert a .092 diameter pin.
3. Tighten screws and remove pin.
ALL
-
REMOVE AND REPLACE AUTOMATIC
TRANSMISSION
1 . Remove wire connector.
2. Remove retaining screws.
3. Remove switch.
4. To replace, position shift tube in drive position.
5. Insert switch drive tang in shifter tube slot and
assemble switch to steering column jacket with ,retain-
ing screws and adjust.
ADJUST AUTOMATIC TRANSMISSION
1. Position and hold the shift lever in low range while
inserting the blade of the reset gage J 23056-2 into the
RESET slot of the switch, Fig. 12-34, exerting
sufficient pressure to insure full penetration (approxi-
mately 9/ 16") of the blade, and remove gage.
2. Insert the blade of "0" gage J 22701-5 into the
ALL-REMOVE AND REPLACE
1.
Fold back carpet in area of switch.
2. Remove wire connector.
3. Remove screws retainig ng switch to toe pan.
4. To replace, reverse removal procedure.
BACK UP LAMP & NEUTRALIZER SWITCH
REMOVE AND REPLACE MANUAL TRANSMISSION
1. Remove wire connector.
2. Remove retaining screws.
3. Remove switch.
4. To replace, position gear selector in reverse, insert
switch drive tang in shifter tube slot and assemble
switch to steering column jacket. Fig. 12-34 Adjusting Back Up and Neutralizer
ADJUSTING GAGE