Cyl. Engine Mounting-Tempest - Pontiac Grand Prix Service Manual

SIX CYLINDER ENGINE
6-7
7. Remove manifold to cylinder head attaching bolts
and clamps and remove manifolds as an assembly.
REPLACE
1. Clean gasket flanges on cylinder head and mani-
folds.
2 . Check for cracks on manifold castings.
3. If necessary to replace either intake or exhaust
manifold, separate them by removing one attaching
bolt and two nuts at center of assembly. Reassemble
manifolds using new gasket. Tighten finger tight and
torque nuts to 25 lb. ft. and bolt to 22 Ib. ft. after
assembly to cylinder head.
4. Position new gasket over manifold studs on cylinder
head and carefully install the manifold in position,
making sure the gasket is in place.
5. Coat face of manifolds liberally with a solution of
graphite in alcohol.
E N G I N E BLOCK
INSULATOR ASSY.
CROSSMEMBER
(6 CYL. E N G . -BOTH SIDES)
Fig. 6-8 6 Cyl. Engine Mounting-Tempest