Removing Parking Pawl Shaft; Removing Oil Pump Attaching Bolts; Intermediate Servo Piston Assembly; Removing Intermediate Clutch Plates - Pontiac Grand Prix Service Manual

7G-14
1969
PONTIAC SERVICE MANUAL
Fig. 7G-22 Removing Parking Pawl Shaft
6. Remove intermediate overrun brake band, direct
and forward clutch assemblies from case (Fig. 76-26).
7. Remove forward clutch housing-to-input ring gear
thrust washer from ring gear (or clutch housing).
NOTE: Washer has three (3) wide external tangs.
8. Remove input ring gear (Fig. 76-27).
9. Remove input ring gear-to-output carrier thrust
washer from ring gear (or output carrier).
NOTE: Washer has four (4) internal tangs.
10. Using a finely pointed awl and a small screwdriver,
Fig. 7G-24 Removing Oil Pump Attaching Bolts
remove output carrier-to-output shaft snap ring. Dis-
card ring.
11. Remove output carrier assembly AFig. 76-28).
12. Remove sun gear drive shell assembly (Fig.
76-29).
13. Remove sun gear drive shell-to-low and reverse
roller clutch inner race thrust washer from drive shell
(or inner race).
NOTE: Washer has four (4) wide internal tangs.
14. Remove low and reverse roller clutch support-to-
-case retaining ring (Fig. 76-30).
t
J F
INTERMEDIATE CLUTCH
I
Fig. 7G-23 Intermediate Servo Piston Assembly
Fig. 76-25 Removing Intermediate Clutch Plates