Installing Manual Shaft To Case; Installing Front Band; Installing Detent Lever And Jam Nut To Manual Shaft - Pontiac Grand Prix Service Manual

TURBO HYDRA-MATIC-M-40 73-53
Fig. 7E-158 Checking Rear Unit End Play
transmission case, using a 3/4" dia. rod to seat the
seal.
b. If removed, insert actuator rod into manual detent
lever from side opposite pin.
c. Install actuator rod plunger under parking bracket
and over parking pawl (Fig. 7E-160).
d. Install manual shaft through case and detent lever.
e. Install detent retaining hex lock nut on manual shaft
and tighten to 20 Ib. ft. (Fig. 7E-161).
f. Install retaining pin, indexing with groove in manual
shaft. Rotate transmission to vertical position and
remove J 2 1795.
17. Install direct clutch and intermediate spran assem-
Fig.
7E-159
Installing Front Band
Fig. 7E-160 Installing Manual Shaft to Case
bly. It will be necessary to mist housing to allow sprag
outer race to index with composition clutch plates.
Housing hub will bottom on sun gear shaft (Fig.
7E- 162).
NOTE: Removal of direct clutch composition and steel
plates may be helpful.
18. Install forward clutch hub to direct clutch housing
thrust washer on forward clutch hub. Retain with
petrolatum.
19. Install forward clutch and turbine shaft, indexing
direct clutch hub so end of mainshaft will bottom on
end of forward clutch hub. When forward clutch is
Fig. 7E-161 Installing Detent Lever and Jam Nut to
Manual Shaft