Stator Shaft Front Bushing; Stator Shaft Rear Bushings; Installing Stator Shaft Front Bushing; Installing Stator Shaft Rear Bushings - Pontiac Grand Prix Service Manual

TURBO HYDRA-MATIC TRANSMISSION M-38
7 6 -2 5
( TO RADIATOR
I
CONVERTER FEED
COOLER OUT
Fig.
76-56
Pump Cover and Stator Shaft Oil
Passages
STATOR SHAFT FRONT BUSHING
a. Thread Bushing Tool J 21465-15 into stator shaft
front bushing, thread Slide Hammer J 2619 and
Adapter J 2619-4 into Bushing ,Tool and clamp Slide
Hammer handle into vise. Grasp pump cover hub and
remove bushing. Discard bushing (Fig. 76-57).
b. Install new bushing into front end of stator shaft by
using Bushing Tool J 21424-7 and Drive Handle J
8092. Tap bushing into shaft to .250" below front face
of shaft (Fig. 76-58).
STATOR SHAFT REAR BUSHINGS
a. Remove front bushing as described above. Then,
SLIDE HAMMER
PUMP COVER
A N D STATOR
SHAFT ASSEMB
Fig. 76-58 Installing Stator Shaft Front Bushing
thread Bushing Tool J 21424-7 in@ Extension J
21465-13 and Drive Handle J 8092. Place tool
assembly through front of stator shaft and drive out
center and rear bushings.
,
b. Install new center bushing into hub end of pump
cover by using Bushing Tool J 23062-2, Extension J
21465-13, Drive Handle J 8092 and drive bushing to
approximately 1 1 /32" below face of pump cover hub.
Then, install new rear bushing in same manner flush
to .O10" below face of pump cover hub (Fig. 76-59).
ASSEMBLY
1. If oil pump body oil seal was removed, place pump
PUMP COVER
A N D STATOR.
SHAFT ASSEMBL
Fig.
76-57
Removing Stator Shaft Front Bushing
Fig.
76-59
Installing Stator Shaft Rear Bushings