Pontiac Grand Prix Service Manual page 281

6-42
1-
PONTIAC SERVICE MANUAL
TRANSMISSION EXTENTION
ENGINE BLOCK
STARTER MOTOR BRACE
VIEW A
BOT H SIDES
Fig. 6-74 Grand Prix Engine Insulators
6. Position new insulators against engine and install 7. Lower engine.
attaching bolts and washers. Tighten to 70 lb. ft.
torque. 8. Install frame bracket to insulator bolts with
lockwashers and tighten to 30 lb. ft. torque.
9. Lower rear of engine and transmission so that rear
insulator positions on cross member. Install two cross
member to insulator bolts and washers and tighten to
30 lb. ft. torque.
REAR INSULATOR
-
REMOVE AND REPLACE
1. Remove two cross member to insulator bolts.
2. With suitable lifting equipment, raise transmission
at rear to provide clearance for removing insulator to
transmission housing bolts.
3. Remove two insulator to transmission bolts and
remove insulator.
4. Install new insulator with two insulator to transrnis-
sion housing bolts and washers and tighten to 30 lb. ft.
torque.
5.
Lower rear of transmission so that insulator
positions are above cross member.
Fig. 6-75 Engine Lifting Tool Installed
-
Pontiac and
6. Install two cross member to insulator bolts with
Tempest
washers and tighten to 30 lb. ft. torque.