Installation Of Modulator And Converter; Installing Converter Assembly - Pontiac Grand Prix Service Manual

7G-48 1%9
PONTIAC SERVICE MANUAL
with retaining clip,. depress clip and install speedome-
ter drive gear into position on output shaft (Fig.
7G-12).
3. Install extension housing-to-case square cut O-ring
seal and attach extension housing to transmission case.
NOTE: Speedometer driven gear opening should be on
L.H.
side of housing.
4. Install four (4) extension housing-to-case bolts,
torquing to 3 5 1 . ft.
5. If extension housing lipoil seal was removed, install
new extension housing lip oil seal by using Seal
Installer J 5 154.
NOTE: Outer diameter of seal should be coated with a
non-hardening sealer prior to installation.
6. Install speedometer driven gear, retainer and bolt.
Torque bolt to 12 lb. ft.
1. Install vacuum modulator valve into its case bore,
lubricate new O-ring seal with transmission fluid and
install on modulator.
2. Install vacuum modulator assembly, with stem
pointing up, install retaining clip, with tangs of
retainer pointing toward modulator and install its
attaching bolt to transmission, torquing to 12 lb. ft.
3. Install converter assembly into transmission, making
certain that converter hub drive slots are fully engaged
with oil pump drive gear tangs and converter is
installed fully towards rear of transmission (Fig.
7G- 125).
4. Retain converter assembly to transmission with
Converter Holding Clamp J 2 1366, remove transmis-
sion assembly from bench, place in portable jack and
remove Transmission Holding Fixture and Adaptor.
FIREBIRD DRIVELINE DAMPER
A drivehe damper is used to reduce power train
vibration to an acceptable level. The damper is
mounted under the rear of the transmission extension
and consists of a weight retained by a mounting which,
in turn, is attached to the underside of the transmission
extension through an adapter (Fig. 70-126).
INSTALLATION OF TRANSMISSION
Installation of the transmission assembly is the reverse
of REMOVAL O F TRANSMISSION ASSEMBLY,
as stated o n page 7G-10. After installing, adjust the
detent cable and check and adjust the fluid level.
MANUAL LINKAGE
Manual and back drive linkage adjustments and the
associated neutralizer switch are important from a
I
I
TORQUE SYMBOL
IS ADJACENT TO
CALLOUT FOR
MEMBER TO BE
TORQUED.
Fig. 76-125 Installing Converter Assembly
Fig. 76.126 Driveline Damper