Blower Motor Impeller Andor Blower Motor Case; Air Inlet Assembly Typical Pontiac, Tempest And Grand Prix - Pontiac Grand Prix Service Manual

1A-32 1969 PONTIAC SERVICE MANUAL
Fig. 1A-49 Air Inlet Assembly Typical Pontiac,
Tempest and Grand Prix
SIDE O F DASH PANEL
AND
Assr.
FIREBIRD
-
REMOVE AND REPLACE
I
3. Loosen lower rear fender retaining screws to allow
bottom of fender to move.
Firebird air inlet is composed of two air valves
wntrolled by vacuum diaphragms. One valve is 4. Remove fender skirt. (On FIREBIRD first remove
located in the kick pad and the other in the right hand battery and tray and then remove fender and skirt as
plenum area. Refer to Fig. 1A-50 for service informa- an assembly.)
tion.
5. Remove blower motor or inlet duct retaining screws.
BLOWER MOTOR IMPELLER ANDOR
(If remoVing inlet duct, remove P.O.A. valve heater
BLOWER MOTOR CASE
hoses and screws retaining duct to right case half.)
ALL-REMOVE AND REPLACE
1. Unclip hoses from fender skirt.
2. Remove rocker molding.
6. Remove motor feed wire and cooling tube.
7. Remove motor and impeller.
8. To replace reverse removal procedure.