Installing Parking Shaft Retaining Spring; Installing Parking Pawl Return Spring; Installing New Cup Plug; Installing Rear Band - Pontiac Grand Prix Service Manual

TURBO HYDRA
Fig.
7E-150
lnstalling Parking Shaft Retaining
Spring
6. Install rear band so that two lugs index with two
anchor pins. Check to make sure band is seated on
lugs (Fig. 7E- 153).
7. Install proper rear selective washer (proper washer
determined by previous end play check) into slots
provided inside rear of transmission case.
NOTE:
D i p
washer in transmission oil before installa-
tion.
8. Install complete gear unit assembly into case, using
Tool J 21795 (Fig. 7E-154) and making certain center
support bolt hole is properly aligned with hole in case.
9. Install center support to case retaining snap ring,
with its bevel side up and locating gap adjacent to
band anchor pin. Make certain ring is properly seated
in case (Fig. 7E- 155).
10. Install the case to center support bolt by placing
the Center Support Locating Tool J 23093 into case
direct clutch passage, with handle of tool pointing to
Fig.
7E-152
lnstalling Parking Pawl Return ~priilg
right as viewed from front of transmission and parallel
to .the bell housing mounting face (Fig. 7E-156).
Apply pressure downward on tool handle, which will
tend to rotate the center support counterclockwise as
viewed from front of transmission. While holding
center support firmly counterclockwise against the case
splines, torque the case to center support bolt to 20-25
ft. Ibs.
CAUTION: When using the locating tool, use care not
to raise burrs on the case valve body mounting face.
11. Lubricate with transmission oil and install three (3)
steel and three (3) composition intermediate clutch
plates. Start with the waved steel and alternate
composition and steel clutch plates (Fig. 7E-157).
12. Install intermediate clutch backing plate, ridge up.
13. Install backing plate to case snap ring, locating gap
opposite band anchor pin.
Fig.
7E-151
lnstalling New Cup Plug Fig.
7E-153
Installing Rear Band