Installing Direct Clutch Assembly; Installing Forward Clutch And Turbine Shaft; Installing Pump Seal - Pontiac Grand Prix Service Manual

7 3 - 5 4
1969 PONTIAC SERVICE MANUAL
Fig 7E-162 Installing Direct Clutch Assembly
Fig. 7E-165 Checking Front Unit End Play
seated, it will be 1 1/4" from pump face in case (Fig.
7E- 163).
20. Install gasket and front pump.
21. Install all but one pump attaching bolt and seal.
Torque to 18 lb. ft.
NOTE: If turbine shaft can not be rotated as pump is
being pulled into place, forward or dir ct clutch housing
has not been properly installed in in
f
ex with all clutch
plates. This condition must be corrected befbre pump is
pulled filly into place.
22. If necessary, install a new front seal, using Tool J
2 1359 to drive seal in place (Fig. 7E- 164).
23. Check front unit end play as follows (Fig. 7E-165):
a. Install a 5/ 16"- 18 threaded slide hammer or J 6 125
into bolt hole in pump.
Fig. 7E-163 Installing Forward Clutch and Turbine
b. Mount a dial indicator on rod and index indicator to
Shaft
register with end of turbine shaft.
c. Push turbine shaft rearward.
d. Push output shaft forward.
e. Set dial indicator to zero.
f. Pull turbine shaft forward.
Read resulting travel or end play - should be .003" to
.024". Selective washer controlling this end play
washer located between' pump cover and forward
clutch housing. If more or less washer thickness is
required to bring end play within specifications, select
proper washer from the cahrt below:
NOTE: An oil soaked washer may tend to discolor. It
will be necessary to measure washer for its actual
thickness.
Fig. 7E.164 Installing Pump Seal
24. Install remaining front pump attaching bolt and
seal. Torque 18 1b. ft.