Extension Housing Seal; Extension Housing Seal And Bushing - Pontiac Grand Prix Service Manual

THREE-SPEED SAGINAW MANUAL TRANSMISSION 7B-3
A
STEERING COLUMN
EARSHIFT CONTROL
GEARSHIFT CONTROL
ROD (1st
81
REV:)
ROD
(3rd 81 4 h )
SHIFTER LEVER
@
LUBRICATE WITH
CHASSIS LUBRICANT
/G\
20 LB. FT.
A
15 LB. FT.
TORQUE SYMBOL IS
ADJACENT TO CALLOUT
-
FOR MEMBER TO BE
TORQUED
SWIVEL CLAMP
VIEW B
-
VIEW C
0
Fig. 78-2 Firebird Column Shift Controls
MINOR REPAIRS
EXTENSION HOUSING SEAL
REMOVE AND REPLACE
1. Remove propeller shaft as outlined in Section 4C.
2. Remove seal by prying out with screwdriver.
3. Wash counterbore with cleaning solvent and inspect
for damage.
4. Inspect propeller shaft yoke for nicks, burrs or
scratches which would cut new seal or cause seal to
leak or damage bushing.
5. Coat new seal with sealing compound and start new
seal in opening.
6. Place Collar J 6403-2 onto Tool J 6403-1 (Fig. 7B-6).
NOTE: Flat side of J 6403-1 must be toward rear of J
6403-1.
8. Tap end of tool with soft hammer to seat seal.
9. Reinstall propeller shaft.
EXTENSION HOUSING SEAL AND BUSHING
REMOVE AND REPLACE
1. Remove propeller shaft.
2. Insert Tool J 483042 over output shaft and tighten
screw.
3. Attach Slide Hammer J 2619. Using hammer, pull
bushing and seal from extension housing (Fig. 7B-7).
4. Start new bushing into extension housing.
5. Using Tool J 6403-1 and soft hammer, tap bushing
into place (Fig. 7B-8).
6. Install new seal, using Tool J 6403-1 and Collar J
6403-2 (Fig. 7B-6) and tapping end of tool with soft
hammer to seat the seal.
7. Place Tool J 6403-1 over end of output shaft.
7. Reinstall propeller shaft.