Removing Low And Reverse Clutch Support Retaining Ring; Removing Clutch Support Retainer Spring; Location Of Clutch Support Retainer Spring; Removing Reaction Carrier Assembly - Pontiac Grand Prix Service Manual

7G-16 1%9 PONTIAC SERVICE MANUAL
Fig. 7G-30 Removing Low and Reverse Clutch
Support Retaining Ring
22. Using Clutch Spring Compressor Tools J 23327-1
and J 23327-2 and Pilot J 21420-2 in end of case,
compress low and reverse clutch piston spring retainer
and remove piston retaining ring (Fig. 76-36).
23. Remove tools, spring retainer and seventeen (17)
piston return springs from low and reverse clutch
piston.
24. Remove low and reverse clutch piston assembly by
applying compressed air to passage shown in Fig.
76-37.
Fig. 7G-31 Location of Clutch Support Retainer
Spring
Fig. 76-32 Removing Clutch Support Retainer Spring
25. Remove outer, center and inner flat seals from low
and reverse clutch piston.
6
26. Move transmission to horizontal position and,
using two (2) oil pan bolts, install Compressor J 23069
on oil pan face, compress intermediate clutch accumu-
lator piston cover and remove its retaining ring.
Remove tool (Fig. 76-38).
27. Remove intermediate clutch accumulator piston
cover and remove O-ring seal from case bore (or
cover), intermediate clutch. accumulator piston spring,
intermediate clutch accumulator piston assembly and
remove inner and outer hook-type seal rings from
piston (Figs. 76-39 and 76-40).
REACTION CARRIER
Fig. 76-33 Removing Reaction Carrier Assembly