Oil Pump And Oil Pump Drive Shaft - Pontiac Grand Prix Service Manual

6-60 1969
PONTlAC SERVICE MANUAL
11. Remove starter assembly, starter motor bracket
and flywheel cover.
12. Position J 22603 ENGINE LIFTING TOOL to
engine and place J 22603-8 CROSS BAR in position
on lifting tool (Fig. 6-75). Bolt tool to timing chain
cover with bolts provided with tool.
13. Using frame jack or hydraulic transmission jack,
support engine at J 22603, remove motor mounts.
14. Loosen rear transmission mount.
NOTE: It may be necessary to remove this mount and
rest rear of transmission on cross member to obtain
necessary clearance.
15. Remove oil pan bolts and raise engine straight up
approximately 4 1/2" and forward approximately 1
1
/ ? I t
16. Remove oil pan by first rotating clockwise (facing
forward) to clear oil pump.
NOTE:
If
work other than oil pan gasket replacement is
to be performed, remove jack and support engine with
suitable blocks of wood.
REPLACE
1. Install new gasket on oil pan (Fig. 6-101, 6-102,
6-103).
2. Replace oil pan. Tighten retaining bolts to 12 lb. ft.
Fig. 6-104 Oil Pump and Oil Pump Drive Shaft
3. Install left motor mount to cylinder block and
tighten right motor mount to block bolts.
4. Lower engine and remove J 22603 Engine Support
Bracket.
5. Replace motor mount to frame bolts.
6. Replace flywheel cover, starter bracket and starter.
7. Replace exhaust crossover pipe.
8. Connect steering idler arm to frame.
9. Lower vehicle.
PICKUP
OIL PUMP
REGULATOR
SPRING
REGULATOR REGULATOR
BALL
RETAINER
DRIVE GEAR
A N D SHAFT
Fig. 6-105 Oil Pump
-
Exploded View