Clutch Control Linkage; Clutch; Pontiac Clutch Controls - Pontiac Grand Prix Service Manual

7
-2
1969 PONTIAC SERVICE MANUAL
SERVICE AND REPAIRS 2. Adjust lash. See Clutch Pedal Adjustment under
Periodic Service.
CLUTCH CONTROL LINKAGE
CLUTCH
REMOVE
REMOVE
1. Remove return spring and anti-rattle spring.
2. Disconnect retainer from each end of the clutch
push rod.
3. Loosen nut and lockwasher from ball stud at frame
bracket and remove countershaft assembly.
REPLACE
1. Reverse removal steps. Tighten ball stud nut to 21
lb. ft. torque
1. Disconnect battery to starter lead at battery.
2. Remove propeller shaft and transmission. See
TRANSMISSION SECTION. Exercise care to avoid
damaging transmission front bearing retainer (release
bearing support) when transmission is pulled back to
free main drive (clutch) gear from flywheel housing.
3. Remove clutch release bearing through rear opening
in clutch housing. Do not place bearing in any
degreasing or cleaning solvent.
CLUTCH PUSH ROD
COUNTERSHAFT
6
LUBRICATE WITH CHASSIS LUBRICANT
FOR MEMBER TO BE
TORQUED. ANTI-LASH SPRING
Fig. 7-2 Pontiac Clutch Controls