Removing Parking Shaft Retaining Spring; Removing Parking Pawl Shaft Cup Plug; Removing Front Band - Pontiac Grand Prix Service Manual

TURBO HYDRA-MATIC-M-40 7E-17
Fig.
7E-37
Removing Parking Shaft Retaining Spring
d. If a different washer thickness is required to bring
end play within specification, it can be selected from
the following chart:
AND/OR
THICKNESS STAMPED
(IN INCHES) NOTCHES NO.
.074-.078.
. . . .
.None
I
.082-.086. . . . . . I Tab Side 2
.090-.094.
. . . .
.2 Tab Side
3
.098-.I02 . . . . . . l T a b O . D .
4
.106-.I10 . . . . . . 2TabsO.D. 5
.114-.118.. . . . .
3
Tabs0.D. 6
Fig. 7E-39 Removing Parking Pawl and Shaft with 0
Rfb!
11. Remove case center support to case bolt, using a
3/8" 12 point thin wall deep socket (Fig. 7E-43).
12. Remove intermediate clutch backing plate to case
snap ring.
13. Remove intermediate clutch backing plate, three
(3) composition and three (3) steel clutch plates (Fig.
7E-44).
14. Remove center support to case retaining snap ring
(Fig. 7E-45).
Fig.
7E-38
Removing Parking Pawl Shaft Cup Plug Fig.
7E-40
Removing Front Band