Overhaul And/Or Inspection; Removing Output Ring Gear Needle Bearing; Compressing Low And Reverse Clutch Piston Assembly; Output Ring Gear And Output Shaft Assembly - Pontiac Grand Prix Service Manual

TURBO HYDRA-MATIC TRANSMISSION M-38 7G-17
UTPUT RlNG
EAR TO CASE
E E D L E BEARING
Fig. 76-34 Removing Output Ring Gear Needle
Bearing
OVERHAUL ANWOR INSPECTION
GOVERNOR ASSEMBLY
All components of governor assembly, with exception
of driven gear, are a select
fit
and each assembly is
calibrated. The governor, including driven gear, is
serviced as a complete assembly. However, the driven
gear can also be serviced separately.
While it is necessary to disassemble governor assembly
in order to replace the driven gear, disassembly may
also be necessary due to foreign material causing
OUTPUT RlNG GEAR
Fig. 76-35 Output Ring Gear and Output Shaft
Assembly
Fig. 76-36 Compressing Low and Reverse Clutch
"
,
Piston Assembly
improper operation. To disassemble governor assem-
bly, proceed as follows:
4
DISASSEMBLY
1. Cut off one end of each governor weight pin and
remove pins, governor thrust cap, governor weights
and springs.
NOTE: Governor weighfs are interchangeable from side
to side and need not be identified.
2. Remove governor valve from governor sleeve. Use
care in not damaging valve.
H E R E TO REMOVE LOW &
Fig. 76-37 Using Air to Remove Low and Reverse
Clutch Piston