Installing Reaction Carrier; Installing Roller In Roller Clutch; Installing Center Support To Sun Gear Thrust Bearing And Races; Assembly Of R E A R Unit - Pontiac Grand Prix Service Manual

TURBO HYDRA-MATIC-M-40
73-49
Fig. 7E-142 lnstalling Reaction Carrier
NOTE: When a new output carrier andor reaction
carrier is being installed and
if
the front internal gear
ring prevents assembly of the carriers, replace the front
internal gear ring with the service gear ring.
Fig.
7E-144
Installing Roller in Roller Clutch
a. Install large race, center flange up over sun gear
shaft.
b. Install thrust bearing against race.
c. Install second race, center flange up (Fig. 7E-143).
16. Install rollers that may have come out of the roller
cage by compressing the energizing spring with
forefinger and inserting roller from the outer side (Fig.
7E- 144).
17. Install roller clutch into reaction carrier outer race
(Fig. 7E- 145).
I.D. FLANGED
15. Install center support to sun gear thrust races and 18. Install center support to reaction carrier thrust
hearings, retaining with petrolatum, as follows:
washer into recess in center support. Retain with
petrolatum (Fig. 7E-146).
19. Install center support into reaction carrier and
roller clutch assembly (Fig. 7E- 147).
NOTE: with reaction carrier held, center support
should only turn counterclockwise.
20. Install J 21795 on gear unit to hold units in place.
21. Install output shaft to case thrust washer tabs in
pockets and retain with petrolatum (Fig. 7E-148).
ASSEMBLY OF UNITS INTO
TRANSMISSION CASE
NOTE: The Jirst 3 steps can be omitted if the parts
involved were not removed on disassembly.
1. Install parking pawl, tooth toward inside of case,
and parking pawl shaft (Fig. 7E-149).
Fig. 7E-143
Installing Center Support to Sun Gear
2. Install parking pawl shaft retaining spring -(Fig.
Thrust Bearing and Races
7E- 150).