Disassembly Of Governor; Inspection Of Governor; Removing Rear Internal Gear To Mainshaft Snap Ring; Exploded View Of Governor - Pontiac Grand Prix Service Manual

73-22
i%g
PONTIAC SERVICE MANUAL
calibrated. The governor, including the driven gear, is
serviced as a complete assembly. However, the driven
gear can also be serviced separately.
It is necessary to disassemble governor assembly in
order to replace driven gear. Disassembly may also be
necessary due to foreign material causing improper
operation. In such cases, proceed as follows:
DISASSEMBLY OF GOVERNOR
1. Cut off one end of each governor weight pin and
remove pins, governor thrust cap, governor weights
and springs. Governor weights are interchangeable
from side to side and need not be identified (Fig.
7E-60).
2. Remove governor valve from governor sleeve. Be
careful not to damage valve or sleeve.
3. Perform the following inspections and replace
governor driven gear, if necessary:
I
INSPECTION OF GOVERNOR
Fig. 7E-59 Removing Rear Internal Gear to
Mainshaft Snap Ring
1. Wash all parts
in
cleaning solvent,,air dry and blow
out all passages.
SLEEVE AND CARRIER ASSEMBLY
GEAR RETAINING PIN
DRIVEN GEAR
SPRINGS
(2)
PINS
THRUST CAP SECONDARY WEIGHT (2) PRIMARY WEIGHT (2)
Fig 7E-60 Exploded View of Governor